Skip to main content
Help
/

Site Navigation

Your Account

Choose Language

Editing Step 11 —

Step Type:

Drag to rearrange

Put a lag bolt and washer through the hole in the second disk, then push the tip of the bolt into the hole in the end of the dowel. Tip the disk inward and press it into the foam core, keeping the fabric as neat as you can. You can press the other end’s disk in a little farther to make it easier.

Tighten the second lag bolt with a ratchet wrench, while holding the first bolt with pliers. Neaten your fabric folds at both ends.

Staple 2 small strips of velcro to the headrest support near the top, so their outside edges are 8" apart.

Mount the support to the bevel on cross brace A, exactly in the center, with three #8×1½" screws. Temporarily stick the headrest to the velcro strips on the support and give the chair another test-sit.