Twist the screws into your starter holes.
Cut your dowel rods by clamping them in your bench vise. You need 2 lengths of 20" and 1 length of 16". The latter is your warp bar; it needs to be able to fit inside your frame.
Measure out every 1⁄2" across the top and bot- tom of the front side of your loom. Start by finding the center, and mark every 1⁄2", working your way to the outside of the frame. Make sure you mark the center so that it stands out a bit.
Make notches at every 1⁄2" mark, using your X-Acto knife; just score the frame lightly.
The front of your loom is the side with the modified screw/hooks in it.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.