Skip to main content
Help
/

Site Navigation

Your Account

Choose Language

Editing Step 1 —

Step Type:

Drag to rearrange

WARNING: PVC pipe tends to roll while cutting on a table saw, so hold it firmly and cut slowly. Gripper gloves help. For cutting off sections on a table saw, set the blade just slightly higher than the pipe wall thickness. Don’t use a ruler or tape to set blade height; instead, make trial cuts in a scrap of wood and measure the cuts. Always wear eye protection when using power saws.

Cut and drill the bulb support from ½" plywood, following the diagram.

One 45°-angled cut in the 4" PVC easily allows you to make 2 lamp housings if you wish. Drill the hole in back to fit your switch, 2" from the pipe bottom. Thoroughly sand the angle and the bottom surfaces.